Dry the filament for 2 hours at 45-50✬ in a conventional oven with activated air circulation. In this case, increase the extruder temperature up to 260✬ and extrude Filaflex until it comes out very fluid and without stains. Its an all in one 3D Printing software that can take in 3D models, arrange them, slice them (slicing means turn the. Well, this page is not supposed to scare you on your FDM printing. Sometimes the pressure on the filament is insufficient and it slips, thus preventing a continuous and stable extrusion.Ĭheck and clean the nozzle, since it may be partially blocked, especially when you have changed from a rigid material such as ABS, PETG, etc., to a flexible one. After the assembly of your KAY3D CoreXY machine, youll probably run into certain issues. Increased pressure on the filament in the extruder. RepRap Wiki Pictorial Troubleshooting Guide and Descriptive Troubleshooting Guide, these are a bit more technical/ advanced. Simplify 3D Visual Troubleshooting Guide. Sometimes this problem is solved by increasing the temperature. These guides can help you identify and solve any issues youre experiencing: rigid.ink poster. This is usually caused by an insufficient extrusion problem and can be solved by adjusting a series of parameters. Sometimes, we can perceive that the extrusion lines are not well defined, have bald spots or are very poor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |